Calendar

Cafeteria menus

To overview

Location & approach

Plan of site & interactive map

The facilities of TU Dortmund University are located on two campuses, the larger North Campus and the smaller South Campus. In addition, some university facilities are located in the adjacent Dortmund Technology Park as well as in the city center and the wider urban area.

> Go to interactive map

ServicePortal UniMail

Contrast Deutsch

Calendar

Cafeteria menus

To overview

Location & approach

Plan of site & interactive map

The facilities of TU Dortmund University are located on two campuses, the larger North Campus and the smaller South Campus. In addition, some university facilities are located in the adjacent Dortmund Technology Park as well as in the city center and the wider urban area.

> Go to interactive map

ServicePortal UniMail

News

Formability of High Temperature Stainless Steel Grades

Experimentally determined forming limit curves and geometry of utilized specimen

Direct recycling of aluminium: Chip Extrusion

Hot extrusion of compacted aluminium chips is a direct recycling method without remelting. Hot extrusion enables a wide product spectrum with good…

Development of a Model to Predict Geometry Changes in Spring Manufacturing Based on Plasticity Theory Considering Heat Treatment

a) Process chain for the production of compression springs, b) Residual stresses in the wire cross section

Analysis of the Application Potential of Roll-Clad MnB-Cr Steel Composites for Press Hardening

a) Hardness of the composite, b) Validation of the analytics

Preparing the Standardization of the In-Plane Torsion Test

Overview of the four main fields of influences on the test results of the in plane torsion test.

Hot Plate Forging of Load-Adapted Gear Racks

a) Schematic depiction of the plate forging process, b) Effective plastic strain distribution in the gear rack after forming

Application and Analysis of Adiabatic Blanking

a) Comparison of strain localization, b) Effect of the strain rate sensitivity on forming energy

Longitudinal Mechanical Joining of Extruded Aluminum Profiles with Increased Tightness Requirements

Longitudinal joining: equivalent plastic strain, contour comparison, and microstructure image

Functionalization of Additively Manufactured Hot Stamping Tools Using Ball Burnishing

a) Surface properties, b-d) Additive manufacturing of cooling channels: procedure and preliminary tests